Stick on floor tiles – Stick-on vinyl tiles come with adhesive already applied to the backs of the tiles, so you do not have to extend down the adhesive when applied to the soil surface. Instead, just out of waxed paper backing and press the sticky mosaic floor. Adhesive tiles need a flat surface to stick properly. You can apply stick-on tiles concrete floors that are flat and undamaged, with no cracks. The cleanup step not skips because any residual grease or dirt will cause the adhesive to fail.
Applying stick on floor tiles, mix ½ cup disodium phosphate in about a gallon of water. Fully mop the concrete floor, and then rinse with clear water-mop. Let dry for 48 hours. Take a line with your chalk line capture from the middle of one edge of the floor to the middle of the edge through it, dividing the floor in the middle. Take a perpendicular line on the ground, the intersection of the first line. Set a place at the intersection before you snap the second line to make sure it is exactly perpendicular to the first.
Remove the backing from the first tile. Pull the backing off the second tile and put in place next to the first, with the edges firmly to stop. Press down firmly. Measure the spaces around the perimeter of the plant, where full tiles may not fit, and cut partial tiles for areas with his knife. Run the knife next to his place to get a straight cut, scoring the surface of the tile, and bend the tile until it snaps into the line. Install the stick on floor tiles around the perimeter with cut sides facing the walls.
12 Applying Stick On Floor Tiles Design Photos